ware. Contact us for ordering information.
In addition to HHT control,
W
i
An installation
computer.
able (M
P
/ N 03-3156A01)
ndows- based software is avail-
ײª·-·¾´» °´¿½» ¸±´¼»®
Figure 8. RSSI vs. Vdc (Typical)
4.0
TRANSCEIVER PROGRAMMING
To program and read the transceiver, use the radio
’
s RJ-11
DIAG
(Diagnostics) connector with a personal computer through a diagnostic cable .
ontains a reference chart (
Table 9
) and detailed descriptions
for each user command.
4.1 Radio Programming Methods
2
2.5
3
3.5
4
–
11
0
–
90
–
70
–
50
4.5
5.0
SIGNAL LEVEL (dBm)
+
DC
V
O
LT
S
(
P
IN 21)
This section c
IMPORTANT!!!
05-3305A01, Rev. E 15
NOTE:
to allow diagnostics and
programming using a personal
booklet and on-line instructions are included with the soft-
PC with Radio Configuration Software
NOTE:
When using radio configuration software, click on the opening
screen or press a key to activate the program.
PC in Terminal Mode
A PC may also be used
©·¬¸±«¬
the Radio Configuration software by
operating it in a basic terminal mode (e.g., HyperTerminal session) and
entering the radio commands listed in
Table 9
.
̸» ¬»®³·²¿´
½±³³«²·½¿¬·±² °¿®¿³»¬»®- ³«-¬ ¾» -»¬ ¬± çêðð ¾°-ô ©·¬¸ è ¼¿¬¿
¾·¬-ô ²± °¿®·¬§ô ¿²¼ ï -¬±° ¾·¬ øèÒï÷ò
1.Connect a diagnostic cable between the computer or laptop and the radio.
2.Connect the power supply to the radio .
3.With the radio is connected to the computer in Radio configuration software.
4.Ensure the correct port is selected in the Commport field in the confirgration ribbon.
Summary of Contents for 1710 Series
Page 55: ...05 3305A01 Rev E 47 NOTES...
Page 56: ...48 05 3305A01 Rev E...
