WDS 1710 Series, Technical Manual

Page: 13 / 62

05-3305A01, Rev. E 5
1.5 Accessories
The transceiver can be used with one or more of the accessories listed in
Table 3 . Contact us for ordering information.
2.0 INSTALLATION
There are three main requirements for installing the transceiver:
•
Adequate and stable primary power
•
A good antenna system, and the correct data connections between
the transceiver, and
•
The data device.
Figure 4 shows a typical remote station arrangement.
Table 3. Optional Accessories for 1710/2710/4710/9710 Transceivers
Accessory Description
MDS
P/N
Power Supply Kit Provides nominal 13.8 Vdc from a
120 Vac power source. Includes DC
cable for transceiver.
01-3682A01
Hand-Held Terminal
Kit (HHT)
Terminal that plugs into the radio for
programming, diagnostics and control.
Includes carrying case and cable set.
02-1501A01
RTU Simulator Test unit that simulates data from a
remote terminal unit. Comes with
polling software that runs on a PC.
Useful for testing radio operation.
03-2512A01
Orderwire Module External device that allows temporary
voice communication. Useful during
setup and testing of the radio system.
02-1297A01
Orderwire Handset Used with Orderwire Module (above)
Standard Handset
Handset with PTT
12-1307A01
12-1307A02
RJ-11 to DB-9 adapter Used to connect a PC to the radio ’ s
DIAG (Diagnostics) port
03-3246A01
EIA-232 to EIA-422
Converter Assembly
External adapter plug that converts the
radio ’ s DATA INTERFACE connector
to EIA-422 compatible signaling.
03-2358A01
Radio Configuration
Software
Provides diagnostics of the transceiver
(Windows-based PC required).
03-3156A01