![background image](http://html1.mh-extra.com/html/wayne-dalton/firestar-540/firestar-540_installation-instructions-manual_3941862015.webp)
344940 REV2 03/17/2020
©
Copyright 2020 Wayne Dalton, a division of Overhead Door Corporation
15
Rotate barrel assembly until top slat attachment point is accessible. Feed top slat around back side of barrel assembly until top slat is out in front of barrel assembly. Install the
top slat attachment bolts and nuts, verifying that the curtain is centered between the brackets.
Continue rolling the curtain up around the barrel assembly until the entire curtain is coiled onto the barrel assembly. Clamp or block the guide assembly approximately 6”
down from the top of the guides. Loosen the safety ropes enough to let the curtain feed into the guide grooves.
STEP 7
INSTALLING INNER GUIDE ASSEMBLY
With the curtain and barrel assembly (not shown for clarity) now mounted to the guides and secured to prevent curtain from dropping, proceed to install the inner guide
assembly. Position the bottom bar inside the channel shaped outer guides approximately 3”-4” below the top of the guide opening.
Install the bottom bar stops to the inner guides as shown in Detail ‘B’.
Position the correct inner guide into the outer guide so that the inner angle holes line up with the outer guide slots. Attach the inner guide using the truss head bolts and
acorn nuts that were shipped installed in the guide assembly.
Repeat this procedure with the opposite guide assembly.
Install the slide lock strike tabs (if ordered with locks).
WARNING
NO TENSION HAS YET BEEN APPLIED TO DOOR. IF CURTAIN IS ALLOWED TO ROTATE AND FREE FALL, SEVERE OR FATAL INJURY COULD RESULT. KEEP THE CURTAIN
SECURE AND PREVENT FROM ROTATING.