Managing Network Interfaces
35 Wavion
Table- 3.4
Wireless page
Field
Description
Operational Status
Up/Down
BSSID
Identifier MAC address of the BST
Operational Channel
The wireless channel used by the unit. See Setting the
Operational Channel
Transmission Power
Default Max=1 for maximum Tx Power and Min=6 for lowest Tx
Power. It's a 3dB steps. Should be set to maximum for most
applications.
Beacon Period (Kusec)
Amount of time between beacons in kilomicroseconds. One Kusec
equals 1,024 microseconds, which is close to 1 millisecond.
Default is 100ms. Not configurable.
DTIM Period (Beacon
intervals)
Determines how often the beacon contains a Delivery Traffic
Indication Message (DTIM). This message “wakes up” any CPE in
power-save mode. Not configurable
Range
Sets the maximal distance for an associated CPE based on radio
propagation delay. Values: 2.8,5,10 and 15Km
Association aging
timeout
The amount of time after which an inactive CPE (a CPE that
neither received nor transmitted data) is disassociated from the
BST. The minimum value is 5 minutes, maximum is 30 minutes.
The default value is 15 minutes.
Interference
Handling Mode
Selects the way the system handles the interferences. It can be
set to any of the following four modes:
•
Interferences Mode
•
Moderate Interferences Mode
•
High Interferences Mode
The recommended mode is Interferences mode
Frequency Planning
Consideration
•
Standard
: System works in standard (20MHz) channel
separation
•
Overlapping
: System is optimized for 15MHz channel
separation
Note: Enabling the Overlapping mode will decrease the Tx power
by about 3dB.
Traffic Optimization
