Advance Settings for the v
9
S
Single
Com Port System
Advance Encoder Settings
To enter the
“Advanced Encoder Settings”
Screen you must type in the User ID
“Maint”
(Not Case Sensitive)
.
Click
“OK”.
See Fig. 15
A
Fig. 15
A
(Enter Password
“Maint”
)
Below is the Advanced Encoder Settings Screen.
In
MOST
cases you will
NOT
have to adjust these settings.
The “
Restore Defaults
” Button will set each field back to the original default settings and affects the
Entire
screen.
When finished,
Click
“OK”.
See Fig. 16
A
Fig. 16
A
(Default Settings) For the
SPS-5 v
9
S Single
Com Port Settings Screen
Advance Encoder Settings
–
“Default Settings”
: (As Shown) Fig. 16
A
A
: Carrier Detect = 0v
B
: Transmitter Duty Cycle = 66% and Carrier Signal Detection is “ON” (Checked)
C
: Data Encoding Polarity = Normal
D
: Max Messages per Batch = 10 and Increment Cap Codes by 8 is “OFF” (Not Checked)
E
: Settings for
Com Port = Serial Port RESET of Timed Paging (Checked) and
Flow Control- Setting = Hardware (RTS/CTS)
F
: Restore Defaults- This Button will set the Entire Screen to Original Factory Default Settings.
G
: Paging Site License Call Sign- Station ID Information - Sent in
Morse Code
approx. every 30 Seconds
For Programming/Reading/Saving the Database and Settings: (See Next Page).
