To enter the “
Advanced Encoder Settings
” Screen you must type in the User ID
“
Maint
”
(Not Case Sensitive)
.
Click
“OK”.
See Fig. 15
Fig. 15 (Enter Password
“Maint”
)
Below is the Advanced Encoder Settings Screen.
In
MOST
cases you will
NOT
have to adjust these settings.
The “
Restore Defaults
” Button will set each field back to the
Original Default
settings and affects the
Entire
screen.
When finished,
Click
“OK”.
See Fig. 16
Fig. 16 (Default Settings)…For the
SPS-5 v
9
Dual
Com Port Settings Screen
Advance Encoder Settings
–
“Default Settings”
:
(As Shown) Fig. 16
The following are
“Global”
and affect
BOTH
Com Ports.
A
: Carrier Detect = 0v
B
: Transmitter Duty Cycle = 66% and Carrier Signal Detection is “ON” (Checked)
C
: Data Encoding Polarity = Normal
D
: Max Messages per Batch = 10 and Increment Cap Codes by 8 is “OFF” (Not Checked)
F
: Restore Defaults- This Button will set the
“Entire Screen”
including
both com ports
to original default settings.
G
: Paging Site License Call Sign- Station ID Information - Sent in
Morse Code
approx. every 30 Seconds
The following affect
ONLY
the
1st Com Port
:
E
:
1
st
Com Port = Serial Port RESET of Timed Paging
Flow Control- Setting = Hardware (RTS/CTS)
The following affect
ONLY
the
2
nd
Com Port
:
H
:
2
nd
Com Port = Serial Port RESET of Timed Paging
Flow Control- Setting = Hardware (RTS/CTS)
