Wavetronix Click 500 Series, User Manual

Page: 66 / 109

CHAPTER 7
• CLICK 512 65
3
Detection event is generated one second after the vehicle leaves the beam. This one-sec-
ond delay is fixed. Output is activated as soon as the event is received by the Click 512.
4
Output is deactivated at the end of the duration.
Note
In run mode, it is now possible to configure the Click 512 thresholds and other set-
tings using Click Supervisor without changing to Device Setup Mode. This allows the
settings to be updated remotely. For remote management, an IP connection via a
Click 301 (or equivalent device) needs to be available via the RS-232 top port. Only the
RS-232 top port is available for remote management when in the Run mode.
Device Setup Mode (green solid)
Device Setup mode is the second mode presented in the mode selection process. This mode
allows you to configure threshold variables and set up communications with the Click
104/112/114.
First put the device in Device Setup mode (solid green). Once in Device Setup modem, use
submenu 1(yellow LEDs) to select which connection you will use to connect Click Supervi-
sor:
˽ First LED solid – This is the primary mode for connection and will be the option you
select most often. You can connect to Click Supervisor over the serial RS-232 port and
do necessary troubleshooting.
˽ Second LED solid – The second mode is a backup mode if there are no other means to
connect to the device. You can connect to Click Supervisor over the RS-485 port. This
mode will not forward information correctly to the Click 104; after the Click Supervi-
sor configuration, the device will need to be changed to submode 1.
The Click 512 is then configured using the Click Supervisor software. See Chapters 4 and 5
of this document for instruction on how to download and install Click Supervisor and how
to connect to your device using the software.
How to use Click Supervisor to work with your device will be covered in the Computer
Configuration section of this chapter.
Next, connect the Click 104/112/114 device via the RS-485 top/front port. When using a
Click 104, you will need to use a gray T-bus to isolate communications sent from the RS-
485 top/front port (so they do not collide with communications on the Click 512 RS-845
T-bus port). When using a Click 112/114, patch across using an RJ-11 jumper cable.
Once the Click 104/112/114 device is connected, you will need to autobaud it and then put it
in Actuation mode. This can only be done when the Click 512 is in the Device Setup Mode.