Wavetek Wandel Goltermann CLI-1450, Operation Manual

Page: 47 / 102

2-4
Note Note Note Note Note
The characteristics for each type of antenna are programmable. Be
sure that you have enabled all the antenna types that you want to use.
The soft key is only available if there is more than one enabled
type. (see EDIT ANTENNA TYPES in the Leakage Configuration
section).
Note Note
Note Note Note
The antenna selection is only useful for field strength measurements.
If the measurement units you have selected result in an absolute
measurement, the soft key will not be available.
ENTERING THE LEAKAGE DISTANCE ENTERING THE LEAKAGE DISTANCE
ENTERING THE LEAKAGE DISTANCE ENTERING THE LEAKAGE DISTANCE ENTERING THE LEAKAGE DISTANCE
If you find a leak in an inaccessible area, you can enter the estimated
distance from the leak and your CLI-1450 will calculate what the
equivalent field strength would be at the reference distance. These
measurements are adequate for grading leaks you have found and
prioritizing your repair schedule based on leak severity. You should,
however, always perform regulation compliance measurements at the
required reference distance.
Important Important
Important Important Important
The most accurate and repeatable measurements are made using a
dipole antenna located at the required reference distance.
. . . .
This is
the only method recommended by WWG for making regulation compli-
ance measurements.
The leakage distance appears in the upper right-hand corner of the
display. To enter a different value, use the numeric keys followed by
the key.
Note Note
Note Note Note
This feature is only useful when performing field strength measure-
ments. If the measurement units you have selected result in an
absolute measurement, the leakage distance will appear dimmed.