1726 North Ballard Road, Suite 1 - Appleton, WI 54911 - 920.991.9082
Technical Support 855.804.5774 - [email protected]
W
E
PTM30162-C
29 MAR 2018
CRUSH
HAZARD
CUTTING
HAZARD
CRUSH
HAZARD
CRUSH
HAZARD
FALLING
HAZARD
CRUSH
HAZARD
PINCH
HAZARD
PUNCTURE
HAZARD
FRAMELESS CAR
ASSEMBLY
SERIES :
021 - 022 - 114
C
A
B
D
C
A
B
E
D
C
A
B
E
D
F
Do not allow walls to slide off the fl oor this may cause harm to yourself and the walls.
Carefully lift at the connecting corner and connect
the pins in wall
D
into the fasteners in wall
B
.
Drive dowels from fl oor
A
into wall
D
with a rubber
mallet to prevent walls from moving or sliding.
Set
wall
E
into place. Carefully lift wall
E
at the connecting
corner and connect the pins in wall
E
into the fasteners in wall
D
.
Drive dowels from fl oor
A
into wall
E
with a rubber mallet to prevent walls from moving or sliding.
Set
ceiling
F
onto walls
B
,
C
,
D
and
E
with dowels.
Use rubber mallet to drive dowels through the ceiling and into walls.
Fasten ceiling fi rst then fl oor panel to walls with provided hardware in
pre-drilled
locations.
Verify fl ush alignment across top of walls and gate pocket. Use a rubber mallet to bring the walls into
alignment.
Do not rely on ceiling screws to close gaps.
Check to make certain all fasteners are seated
completely and all walls are level.
Note:
Use a small
amount of wax
or liquid soap
for lubricating
hardware.
VERIFY ALL FASTENERS ARE SECURE!
8
10
12
14
Note:
Mod-eez Pin may need to be tightened or loosened to achieve proper fi t between the cab walls.
12.
8.
14.
9.
10.
13.
11.
10.
Page 38
Summary of Contents for Excelevator 114 Series
Page 2: ......
Page 51: ...PAGE INTENTIONALLY LEFT BLANK Page 51 ...
Page 76: ......
Page 77: ......
