![background image](http://html1.mh-extra.com/html/watts/premier-wp4v-50/premier-wp4v-50_installation-operation-and-maintenance-manual_3910972011.webp)
Page 11
Thread the plastic elbow (supplied in the parts bag) onto the
stainless steel connection on the top of tank. Tighten using an
adjustable wrench.
Do not over tighten as plastic could crack.
Step 15
Step 16
Wrap (7 to 12 turns) of Teflon tape clockwise around the male
pipe threads (MPT) on the Stainless Steel fitting on top of the
tank.
Tank Elbow Installation
Do not let the tape cover the opening.
Note:
Connect Blue Tube from “TANK” Port on RO Module to the Tank
Position tank in desired location. Stand it upright or lay it on its side (using the black plastic
stand). Measure the blue tube attached to the RO module port marked “TANK” over to the
tank and cut it to desired length.
Insert the blue 3/8” tube into the open compression side of the elbow previously installed on
top of the storage tank and push in as far as it will go. Tighten the compression nut securely
with a wrench.
Step 17
Step 18
Step 20
Connect the Red Tube from Faucet to RO Module
Insert the open end of the red 1/4” tube attached to the RO faucet
into the 1/4” X 1/4” quick connect fitting on the RO Manifold. Make
sure the tube is pushed in all the way to the tube stop. (See Picture)
Connect red faucet tube.
Green Tube Connection
Step 14
Locate green tube attached to the RO Module. Insert the open
end of the green 1/4” tube into the open 1/4” quick connect fitting
on the plastic water feed valve making sure the tube is pushed in
all the way to the tube stop.
Green Tube
Adapt-a-Valve
Connect the Blue Tube from the Faucet to RO Module
Step 19
Insert the blue 3/8” tube from the faucet into the port on the module marked “FAUCET”.
Make sure the tube is pushed in all the way to the tube stop.
A connection to a refrigerator / ice maker may be tee’d into this blue tube.
Premier offers an ice maker install kit part # 500102 (See Page 22).
Note:
Reverse Osmosis Module Mounting
Step 13
Determine best location for the RO module to be mounted to allow
for future system maintenance. Using the mounting holes on the
bracket, mark the location for the mounting screws on the cabinet
wall under the sink. In the parts bag, locate the two self tapping
screws. Using an electric drill with a Phillips bit, screw them into
the cabinet at the marked location. Hang the module on the screws
using the mounting holes in the bracket