15
Setting the micro-switches and slot initiators:
Carry out the setting according to Matrix. Attention! In the setting instructions, it is
assumed that the valve (looking from above the axis) closes in a clockwise direction!
Kennzeichnung bar-switch-
control
1 =
Article number
2 =
Protection class
3 =
Type designation bar-
switchcontrol
4 =
Type designation switch
5 =
Number of operating
instructions (only for
Ex-protected units)
6 =
Ex-Identification
7 =
Delivery date
Carry out the setting according to Matrix. Attention!
In the setting instructions, it is assumed that the valve
(looking from above the axis) closes in a clockwise direction!
Identification bar-switchcontrol
1 =
Article number
2 =
Protection class
3 =
Type designation switchcontrol
4 =
Type designation switch
5 =
Number of operating instructions
(only for Ex-protected units)
6 =
Ex-Identification
7 =
Delivery date
Setting the micro-switches and slot initiators
15
1
2
3
4
5
6
7
1
2
3
4
5
6
7
Micro switches
Operated switching
Slot initiators
Damped switching
Valve
„OPEN“
„CLOSED“
2-fold
Micro switches
Not operated switching
Slot initiators
Undamped switching
Valve
„OPEN“
„CLOSED“
2-fold
Identification
bar-switchcontrol
I II III
IV V VI
X XI XII
VII VIII IX
1. Open the valve.
2. Insert the adjusting tool according to fig. B/page 12.
3a.
The switch is already operated/damped:
(I)
Turn the adjusting tool anticlockwise until the switch
is no longer actuated/damped. (II)
Keep on turning until switching point is reached. (III)
3b.
The switch is not operated/damped:
(II)
Turn the adjusting tool anticlockwise until switching
point is reached. (III)
1. Open the valve.
2. Insert the adjusting tool according
to fig. B/page 12
3a.
The switch is not operated/damped:
(VII)
Turn the adjusting tool anticlockwise until the switch
is no longer actuated/damped. (XIII)
Keep on turning until switching point is reached. (IX)
3b.
The switch is already operated/damped:
(VIII)
Turn the adjusting tool anticlockwise until swit-
ching point is reached. (IX)
1. Close the valve.
2. Insert the adjusting tool according to fig. A/page 12.
3a.
The switch is already operated/damped:
(IV)
Turn the adjusting tool clockwise until the switch
is no longer operated/damped. (V) Keep on
turning until switching point is reached. (VI)
3b.
The switch is not operated/damped:
(V)
Turn the adjusting tool clockwise until switching
point is reached. (VI)
1. Close the valve.
2. Insert the adjusting tool according
to fig. A/page 12.
3a.
The switch is not operated/damped:
(X)
Turn the adjusting tool clockwise until the switch
is operated/damped. (XI) Keep on turning until
switching point is reached. (XII)
3b.
The switch is already operated/damped:
(XI)
Turn the adjusting tool clockwise until switching
point is reached. (XII)