12
Visit our website at http://watt-age.globalhobby.com or for Customer Service at http://globalservices.globalhobby.com
❑
Slide the motor wires and the servo extension lead through
the hole and test-fit the radio tray into the fuselage. The tray
should fit tightly and the lip around the edge of the tray should
be pushed down firmly against the top of the fuselage.
☞
You may need to sand the inside edges of the fuselage
lightly, using 220 grit sandpaper, so that the radio tray will
fit properly.
Special Tip:
Because it's a tight fit, it's not necessary to glue the radio tray into place. This will allow it to be removed
easily if you ever need to. If your radio tray does not fit tightly, though, we suggest tack gluing it into place using a couple
of small dabs of 5 minute epoxy.
❑
Kwik Bond 5 Minute Epoxy
❑
Excel Modeling Knife
❑
Ruler
❑
Pencil
❑
220 Grit Sandpaper w/Sanding Block
YOU'LL NEED THE FOLLOWING PARTS FROM THE KIT:
❑
(1) Right & Left Wing Panels
SECTION 6: WING PANEL INSTALLATION
❑
(2) Fiberglass Wing Joiner Plates
YOU'LL NEED THE FOLLOWING TOOLS AND SUPPLIES:
❑
Paper Towels
❑
Rubbing Alcohol
❑
NHP Epoxy Mixing Sticks
❑
NHP Epoxy Mixing Cups
Step 1: Cutting Out the Ailerons
❑
Using a modeling knife and a ruler, carefully cut 1/16" off
of the inboard section of the aileron on one wing panel.
☞
Cutting the inboard section of the aileron shorter will
prevent the aileron from hitting the side of the fuselage when
the wing panel is glued into place.
❑
Carefully flex the aileron up and down several times to free up the hinge line.
❑
Repeat the previous procedures to shorten the aileron on the second wing panel.
❑
Using 220 grit sandpaper with a sanding block, lightly sand the root end of each wing panel to remove any paint
overspray, being careful not to distort the angle.
