CHAPTER 3
WIRING
3-8
3.4 Control Terminal Wiring (Factory Setting)
1. Terminal
Explanations:
DO1
DOC
Terminal
symbols
Terminal name
Remarks
RA-RC
Multi-Function Indication
Output Contact
RB-RC
Multi-Function Indication
Output Contact
Refer to Pr.3-06 Relay output contact
Resistor Load
5A(N.O.)/3A(N.C.) 240VAC
5A(N.O.)/3A(N.C.) 24VAC
Inductive Load
1.5A(N.O.)/0.5A(N.C.) 240VAC
1.5A(N.O.)/0.5A(N.C.) 24VDC
Refer to Pr.3-01 to Pr.03-03
DO1-DOC
Multi-function photo coupler
output
Refer to Pr.3-05
RJ-11 Serial
communication
port RS-485 serial communication interface
10V-GND
Power Supply (+10 V)
AVI-GND
Analog voltage/current freq.
command
0 to +10 V (Max. Output Frequency) Input or
4 to 20mA (Max. Output Frequency) Input
AF0-GND
Analog frequency/current
meter
0 to +10 V (Max. output Frequency) Output
DI1-GND Multi-function auxiliary input
DI2-GND Multi-function input 1
DI3-GND Multi-function input 2
DI4-GND Multi-function input 3
DI5-GND Multi-function input 4
DI6-GND Multi-function input 5
Refer to Pr.4-04 to Pr.4-08
17V
Digital Control Signal – the common end
Note:
Use twisted-shielded, twisted-pair or shielded-lead wires for the control signal wiring.
It is recommended to run all signal wiring in a separate steel conduit. The shield
wire should only be connected at the drive. Do not connect shield wire on both
ends.
Wire Gauge: 16-24 AWG
Wire Type: Copper Only
Torque: 0,2Nm (1.7in-lbf)