MAX
This key can be used to prime the pump when in manual mode. When pressed the pump
will operate at maximum flow rate.
FUNCTION KEYS
When pressed will perform the function displayed on the screen directly above the relevant
function key.
After 30 minutes of no keypad activity, the HMI display will dim to 50% brightness.
To restore full power to the display and reset the timer, press the
BACKLIGHT
key.
+/- KEYS
These keys are used to change programmable values within the pump. For example, flow
rate. These keys are also used to move the selection bar up and down in the menus.
MODE
To change modes or mode settings, press the
MODE
key. The
MODE
key can be pressed at
any time to enter the mode menu. If modifying pump settings when the
MODE
key is
pressed, it will disregard any setting changes and return you to the
MODE
menu.
SCREEN SAVER
The display refreshes every 60 seconds. When this occurs you may notice a brief flash.
Screen Icons (Manual, PROFIBUS, Universal and Un only)
Under certain conditions, various icons will appear in the screen display area:
The pump displays a RED stop icon when it is in a manually stopped condition.
In this state the pump will not start unless the START key is pressed.
The pump displays a RED PAUSE icon when it is receiving a remote stop input
whilst in a standby condition. The pump is placed in a standby condition by
pressing the START key in manual mode, or by selecting Analogue mode.
In this state the pump will respond to a change in state of the start/stop input,
and may start automatically when a control signal is received.
When the pump is running it displays a turning icon to indicate a pumping state.
Fundamental work with regard to lifting, transportation, installation,
starting-up, maintenance and repair should be performed by qualified
personnel only. The unit must be isolated from mains power while
work is being carried out. The motor must be secured against
accidental start-up.
m-qdos-en-02
47
