80 MLS User’s Guide
Setup
Setup Loop Outputs
Press Yes at this prompt to access menus to change loop output
parameters for the current loop, including:
•
Enable or disable outputs
•
Output type
•
Cycle time (for TP outputs)
•
SDAC parameters (for SDAC outputs)
•
Control action
•
Output level limit and limit time
•
Output override
•
Nonlinear output curve
Both heat and cool outputs have the same menus, so only one of each
menu is explained in this section. (The next page shows a menu tree.)
Here's the main menu:
The figure on the next page shows the menu tree for the output setup
menus. Notice the default values inside the boxes
LOOP PROCESS UNITS
ALARM SETPOINT STATUS OUT%
SETUP LOOP 03
OUTPUTS ?
Summary of Contents for MLS-PM
