Watlow Anafaze PPC-2000, User Manual, Page: 121 / 320

PPC-2000 User’s Guide Chapter 3: Operating with AnaWin 3
Doc.# 30002-00 Rev 2.3 Watlow Anafaze 97
Setting up Process and Deviation Alarms
To enable alarms on the process variable for a channel follow
these steps. See
Alarms on page 123 for descriptions of the
alarm parameters.
On the Alarms spreadsheet:
1. Set the Alarm Deadband .
2. Set the Alarm Delay .
3. For each alarm you wish to activate:
a. Set the alarm limits in the corresponding fields: LP
Limit, LD Offset, HD Offset, HP Limit .
b. Choose the alarm behavior by setting the correspond-
ing field (
LP Type, LD Type, HD Type, HP Type ) to Alarm or
Control .
c. Choose an available digital output to activate when
the alarm occurs, if desired, in the corresponding field
(
LP Output Dest, LD Output Dest, HD Output Dest, HP Output
Dest ).
4. On the Dig I/O spreadsheet, set the Logic of each output
used for alarms as desired.
5. Return to the Alarms spreadsheet. Enable the alarm by
setting the corresponding field ( LP Enable, LD Enable, HD
Enable, HP Enable ) to Enabled .