Waters Network Systems
2800M/MR User’s Manual
Page 66
The function of GVRP Config is used to configure each port’s GVRP operation mode. There are
seven parameters to be configured which are described below.
Parameter description:
GVRP State Setting:
This function allows you to enable or disable the GVRP function. Use the drop down list and
select the
Downward
arrow key to choose
Enable
or
Disable
. Select
Apply
and the function
will take effect immediately.
Join Time:
Used to declare the Join Time in unit of centisecond. Valid time range: 20 –100 centisecond,
Default: 20 centisecond.
Leave Time:
Used to declare the Leave Time in unit of centisecond. Valid time range: 60 –300 centisecond,
Default: 60 centisecond.
Leave All Time:
A registered device will be de-registered at the end of this time period. If someone still issues a
new join, then a registration will be kept in the switch. Valid range: 1000-5000 unit time, Default:
1000 unit time.
Default Applicant Mode:
There are two modes that indicate the type of participant: normal participant and non-
participant.
Normal:
In the
normal participant
mode, the switch participates normally in GARP protocol
exchanges. The default setting is
Normal
.
Non-Participant:
In the
non-participant
mode, the switch does not send or reply any GARP messages.
The switch listens for messages and reacts for the received GVRP BPDU.
Default Registrar Mode:
There are three types of parameters for
registrar
mode: registrar administrative control value,
normal registrar, fixed registrar and forbidden registrar.
Normal:
The Registrar responds normally to incoming GARP messages. The default setting is
Normal.
Fixed:
The Registrar ignores all GARP messages, and all members remain in the registered
(IN) state.
Forbidden:
The Registrar ignores all GARP messages, and all members remain in the
unregistered (EMPTY) state.
Restricted Mode:
This function is used to restrict dynamic VLAN be created when this port received GVRP PDU.
There are two modes:
disable
and
enable
.
