ST E P 1 2
Using the provided ratchet (K) and handle rest bolts (J), install handle rests (I).
Ensure that the flat surface of the handle rests is parallel to the ground.
Note: This step also secures the footboard to the slanted brackets of the tank assembly.
Do not overtighten the handle rest bolts - permanent damage to the slanted brackets may
result.
K
L
I
J
ST E P 1 3
Remove both footpads (L) from the tank box. With the heel cups facing
upward, slide the footpads underneath the footpad cover plate. Use a flat head
screwdriver to lift the footpads up and over the lip of the cover plate. The
footpads can be adjusted by lifting the top lip of the footpad up to unhook it and
reposition to another hole. Adjust as necessary.
ST E P 1 4
Unravel the recoil belt from the front end pad of the tank assembly. Ensure that
the recoil belt passes over both guide pulleys in the forward riser. Stand the
rower upright to access the bungee and recoil belt. Connect the bungee to the
recoil belt by linking the bungee’s hook with the recoil belt’s D-ring.
1 5 .
1 6 .
I N STA L L I N G T H E TA B L E T A R M
ST E P 1
Using a provided 5mm Allen Key (T), loosen the tie rods
2-3 revolutions.
Note: DO NOT fully unscrew / remove the tie rods.
T
ST E P 2
Slide the tablet arm brackets (S) through the forward riser cap, onto the forward
risers, and hook them onto the tie rods as shown. The taller portion of the
brackets should be in contact with the interior surfaces of the forward risers.
Using a provided 5mm Allen Key (T), secure the tablet arm brackets in place by
fully retightening the tie rods.
Note: You may have to hold the brackets in place while retightening the tie rods.
T
S
S
ST E P 3
With the Orangetheory logo facing outward, carefully place one of the provided
large power banks (Q) in the battery holder located on the front pad of the tank
assembly.
Q
