WL270
Manual
Page 38 – Revision 6‐28‐2019
Always install indoors and place the
Waterlogic WL270
Water Treatment System
on a firm, flat and
stable surface.
1.
Attach the water supply line to the 1/4” feed water hose adaptor fitting on the back of the unit.
Waterlogic
requires the use of a water pressure regulator. Water feed pressure must be
between 40‐60 psi. Turn on the water supply and check for leaks.
2.
Check to ensure that the Red Heater and Compressor Power Switch is the
O=OFF
position.
NOTE:
Switches have internal LED that illuminates when placed in I=ON position.
3.
Connect the power cord to the back of the
Waterlogic WL270
Water Treatment System
and to a
120 Volt supply.
4.
Turn on water supply and allow reservoir to fill.
5.
Fill the Cold Tank. Hold a container under the dispensing faucet, press and hold the cold
dispensing button until a continuous flow of water is obtained. Once a continuous flow is
obtained, release the dispensing button. Cold tank is now full.
6.
Fill the Hot Tank. Hold a container under the
dispensing faucet. Press and hold down the Red
Hot Safety Button (LEFT hand side) dispensing
button followed by the Pressing and Holding down
the Hot Dispensing Button at the same time until a
continuous flow of water is obtained. Once a
continuous flow is obtained, release the main
dispensing button. Hot Tank is now full.
CAUTION!
NEVER TURN ON HEATER BEFORE
FILLING HOT TANK.
Red Heater and Compressor Power Switch
must be in the O=OFF position while the
Hot Tank is empty. Damage could occur
within one minute and the overload (high
limit) will require manual reset if heater is
turned on with an empty Hot Tank.
