WL270
Manual
Page 32 – Revision 6‐28‐2019
3.
Completely remove the Plastic Internal Reservoir from the
WL270 Water Treatment System
.
3a. Remove and discard
the clear silicon
float protector from
the electronic float.
3b. Loosen the water
supply line fitting
from the
Mechanical Float.
3c. Unplug the white
disconnect attached
externally to the
electronic float.
3d. Pull the silicon ¼”
vent line loose from
the Hot Tank where
it attaches to the
Plastic Reservoir.
4.
Scrub the internal surfaces with soapy water using an unused sponge or paper towels.
5.
Rinse well with clean water.
6.
While avoiding touching the wetted surfaces of the reservoir with your hands, reinstall the
Reservoir into the
WL270 Water Treatment System
, reversing the removal steps you performed
prior.
Sanitizing the machine
Materials Needed:
Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
Phillips Screwdriver
Sanitizer ‐ Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
Unused sponges or paper towels
7.
Install the Hose Adaptor fitting that is packed in the accessories bag found in the drip tray onto
the water inlet fitting on the back of the machine.
CAUTION!
DO NOT OVERTIGHTEN
3d
3a
3c
3b