WL270
Manual
Page 39 – Revision 6‐28‐2019
7.
Verify that the UV lamp operates as expected.
WARNING!
ULTRAVIOLET RADIATION.
Protect your skin and eyes against ultraviolet rays.
Never look directly at an operating UV light. Always disconnect before removal.
8.
Move the
Waterlogic WL270
Water Treatment System
into its final operating position. Be sure
that a minimum of 2” clearance is maintained around both the sides and the back of the unit.
This is important to allow proper airflow and heat exchange of refrigeration system.
9.
Level unit using the adjustable feet to level if necessary. Never install on incline.
10.
Turn the Red Heater and Compressor Power Switch to
I=ON
position.
11.
When the unit has reached its Hot Temp Set Point, the heater will cycle off. When the unit has
reached its Cold Temp Set Point Temperature, the compressor will cycle off.
12.
Once the unit is at the target temperature(s), sample the water to ensure water meets
expectations and additional rinsing or adjustment is not required.
13.
Check the unit for any leaks. External Leak Protection is always recommended.