CUBE
Manual
Page 57 – Revision 10‐8‐2018
Always install indoors and place the
Waterlogic CUBE
Water Treatment System
on a firm, flat and
stable surface.
1.
Attach the ¼” flexible tubing to the bulkhead
located at lower rear of unit.
Attach the Pressure Reducer located in the drip
tray with the Flow Arrow in correct orientation
to the tubing already attached to the Cube.
Connect ¼” flexible tubing to the Reducer and
the Water Supply.
Waterlogic
requires the use of a water pressure regulator. Water feed pressure must be between
40‐60 psi.
2.
Turn on the water supply and check all of the connections for leaks.
3.
Connect the power cord to the back of the
Waterlogic CUBE
Water Treatment System
and to a 120
Volt supply.
4.
Turn the Red Power Switch on ‐
I=ON
position.
5.
The unit will run through a self‐test cycle. Once the self‐test cycle has
completed the icon will stop flashing.
Pressure Reducer is shipped in Drip Tray
Factory PN PU‐0013‐L00‐00
Direction of Flow Arrow