CUBE
Manual
Page 33 – Revision 10‐8‐2018
9.
With a Phillips Head Screwdriver, remove one
screw from the UV Lamp Cover Plate.
Remove UV Lamp Cover Plate.
10.
Disconnect the UV Lamp Connector by holding it
and pressing in the clip. Pull the connector
towards rear of the
CUBE
.
11.
Firmly pull up the UV Lamp while only holding the
lamp by the white end caps.
NOTE
: Do not pull the UV lamp out at an angle, as
it may break or damage the internal parts of the
CUBE
.
12.
Remove Front Frame. Front Frame is attached using 6 Phillip Screws.
2 screws are located on the top of the frame.
2 screws are located at the bottom of the frame.
2 screws are located on both sides, underneath the upper part of the frame.