50
According to the U.S. Environmental Protection Agency, levels of air
pollutants may be two to five times, and in some cases, more than 100
times higher that outdoor air levels. The average cubic foot of indoor air
contains 20 million particles, more than 95% of which are smaller than
1 micron (a micron is 1/25,000th of an inch). Most filters simply can’t
capture these small particles. And to effectively clean the air, submicron
particles must be removed.
The Dynamic Air Cleaner efficiently captures an unparalleled 97% of
these particles down to 0.3 microns. Its superior efficiency is the result
of electronic polarization and activated carbon. The filter works by as-
signing polarity to all the particles in the air as well as to the fiberglass
media in the air cleaner. These polarized particles become like small
magnets clinging to each other and to the air cleaner media.
The chart below compares a high efficiency media filter efficiency to the
Dynamic Air Cleaner efficiency with various particle sizes:
Unlike typical electronic air cleaners, it does not create ozone or produce any nuisance zapping noises. This air
cleaner can be installed easily in your new or existing system without ductwork re-configuration. It is simply installed
in the 1-inch filter rack of your geothermal unit.
Cleaning Procedure
The only maintenance that is required is to simply replace the filter media about every 2-4 months. To clean the filter
and replace the media, follow these steps:
• Turn off the power to the unit (at the breaker).
• Open the filter access door on the side of the unit.
• On the Powerhead of the air cleaner, unplug the adapter cord. Make sure that the jack does not touch any
metallic or grounded surfaces which could result in possible damage to the unit.
• Remove the air cleaner. Brush or vacuum dust and debris from the external wire surface of the air cleaner.
• Carefully open the air cleaner by moving the clips. Remove the old (blue) media pad and discard.
• Position a new pad flat and in the center of the frame.
• Close the air cleaner, and clip shut.
• Plug the adapter cord into the Powerhead of the air cleaner.
• Reinstall the air cleaner into the filter rack. Restore power to the unit.
Note:
Because of variations in humidity and temperature, a new media pad may arc or snap slightly when first installed. This
is normal and should cease after a few hours of operation. If the arcing persists and/or is rapid, remove and re-position the
filter pad. If the arcing continues or if the power indicator light on the Powerhead is dim or out, call your dealer. Only Dynamic
replacement media pads can be used in the Dynamic Air Cleaner. Your dealer can supply you with a quantity of replacement
media pads.
Keeping your filter clean is one of the most important things you can do to ensure that your geothermal unit oper-
ates at its peak efficiency and to minimize the potential for premature failure.
For more information, contact your dealer.
Electronic Air Cleaner
PRODUCT INFORMATION FOR UNITS, OPTIONS & ACCESSORIES
CAPTURE EFFICIENCY
PARTICLE SIZE
TYPICAL CONTAMINANT
4-6" PLEATED
DYNAMIC AIR CLEANER
3-10 microns
Pollen, mold, dust, hairspray
98%
99%
1-3 microns
Auto emissions, lead, dust, large bacteria
Not effective
98.6%
0.3 to 1 microns
Tobacco smoke, cooking, smoke, small
bacteria, fine dust, paint pigments
Not effective
97%