22
T
HERMOSTAT
F
EATURES
Number of Heating Stages: 3
Number of Cooling Stages: 2
Changeover: Automatic or Manual
Programmable: 4 periods, 7 days
Adaptive Intelligent Recovery, Daylight Savings Time key ENERGY
STAR® rated
IMPORTANT
—Using a programmable thermostat may not always result
in energy savings. During the heating season, a “setback” of more than
2-3 degrees from one programmed setpoint to the next may result in the
Auxiliary Heat energizing in order to meet a higher setpoint immediately
prior to the next period in order to reach the higher setpoint. The use of
auxiliary heat may offset any savings achieved during the previous set-
back period.
NOTE:
Always press the keys with your fingertip or similar blunt tool.
Sharp instruments like pens and pencil points can damage the keyboard.
S
ETTING
THE
C
URRENT
D
AY
AND
T
IME
1. Press SET CURRENT DAY/TIME.
NOTE:
On initial power up or after an extended power loss, 1:00 pm flashes
on the display until a key is pressed.
2. Press DAY until the current day is displayed.
3. Press TIME ▲ or TIME ▼ until the current time is displayed.
NOTE:
Tapping the Set Current Day/Time will change the time in one hour
increments. If the current time is Daylight Savings Time, press DAYLIGHT
TIME until DST is displayed.
4. Press RUN PROGRAM.
P
ROGRAMMING
THE
F
IRST
D
AY
Start by programming the Wake time and temperature (and fan operation) for any one day:
1. Press WAKE.
2. Press DAY until the desired day is displayed.
3. Press TIME ▲ or TIME ▼ until the desired Wake time is displayed. The program times are in fifteen minute inter-
vals. (Example: 8:00, 8:15, 8:30).
4. Press INCREASE ▲ or DECREASE ▼ key until the desired Wake temperature is displayed. The setpoint
temperature range is 40 to 90°F (7 to 31°C) for heating and 45 to 99°F (9 to 37°C) for cooling.
NOTE:
Press FAN to modify fan operation. Auto means the fan will run only when the heating or cooling equipment
is operating. On means the fan will run continuously for the entire period.
5. Press HEAT/COOL SETTINGS to switch to other system temperature setpoint.
NOTE:
The program times are the same for both heating and cooling.
6. Press INCREASE ▲ or DECREASE ▼ key until the desired temperature setpoint is displayed.
7. Press LEAVE, RETURN or SLEEP and repeat steps 3, 4, 5 and 6 for programming the rest of the day. The first
day is now programmed.
IMPORTANT
— Repeat steps 1 through 7 for each day of the week that has a different program than the first day.
Refer to Copying a Day section in thermostat Owner’s Guide to copy any program day to another.
8. Press RUN PROGRAM when all days are programmed.
S
ETTING
T
EMPORARY
T
EMPERATURES
& C
HANGING
T
EMPERATURE
S
ETTING
U
NTIL
THE
N
EXT
P
ROGRAM
P
ERIOD
Press INCREASE ▲ or DECREASE ▼ key until the desired temperature setpoint is displayed.
NOTE:
If ▼ or ▲ appear under the temperature display, it means that both the heating and cooling setpoints are
being adjusted. Tapping the key will change both the heat and cool setpoints by one degree. Press ( i ) after the
desired setpoint is reached to check the setpoints.
NOTE:
The temporary temperature setting is displayed for approximately 3 seconds. The setting is cancelled when
TP32H03 Thermostat
THERMOSTAT OPERATION