©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
8
106532A1
I N S T A L L A T I O N I N S T R U C T I O N S
26. While keeping the shutter shaft in place
(do not let it
rotate from original position
) apply an amount of glue
rated for automotive plastic adhesion or an epoxy
(e.g.
Gorilla Glue 2 Part Clear Epoxy)
to the end of the shutter
shaft.
NOTE: Do not let the shaft rotate from original
position.
27. Reinstall motor in original orientation.
NOTE: The
motor must be reinstalled in the same position as it was
removed .
28. From the back side of the grille shutter, carefully cut the
motor housing, motor stop and shaft from the shutter as
shown.
IMPORTANT: Be sure the piece you cut, retains
the motor stop.
CAUTION
Always use assistance when moving or lifting heavy parts.
29. With assistance, lift the mount and winch assembly into
place. Secure using the 8 bumper beam mounting bolts
removed in step 16 and the 8 washers (B1) from this kit.
30. Center the mount and tighten to torque specifications
on page 3.
WARNING
Never route electrical cables across sharp edges, over battery terminals, through or
near moving parts, near parts that get hot.
31. Route the power cables along the top of the winch
mount and then behind the headlight as shown.
NOTE:
The cables will come out next to the washer fluid
reservoir.
WARNING
Always connect red (+) power cable ONLY to the positive (+) terminal of the battery.
WARNING
Always connect black ground (-) power cable ONLY to the negative (-) terminal of the
battery.
32. Connect cables to the battery terminals.
Figure 17
Glue here
Motor Stop
Cut
Motor
Shaft
Figure 15
Figure 16
