©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
106532A1
I N S T A L L A T I O N I N S T R U C T I O N S
13. Using a 10mm socket, remove the four clips and two
screws along the top of the grille.
14. In each wheel well remove the 3 plastic push pins by
depressing the center until it clicks, and then lifting the
entire pin out.
15. Along the bottom edge of the bumper, remove the ten
plastic push clips.
16. If equipped, disconnect the connectors of the left and
right fog light assembly.
NOTE: It may be easiest to
reach them once the bumper plastic has been unclipped,
but not yet removed from the vehicle.
17. Carefully, remove the bumper cover by pulling firmly out
and up, starting at the wheel well and working around
the headlight and front of vehicle.
Once bumper cover is fully released from vehicle, set
aside on a protective stable surface.
Figure 9
Figure 10
Figure 11
Figure 8
