©2019 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
7
106532A1
I N S T A L L A T I O N I N S T R U C T I O N S
18. Unclip the temperature sensor by squeezing the tabs on
the back.
19. Unplug the shutter motor on the driver side.
20. Remove the three bolts securing the grille shutter with a
10mm socket.
21. Unsnap the two clips at the lower corners of the grille
shutter by firmly pulling out on the ducting.
22. Remove the grille shutter and lay on a flat, stable
surface.
23. Using a 12mm socket and extension, remove the 8 bolts
securing the bumper beam to the vehicle.
24. Lift up on beam and remove completely.
Save hardware
for later use
.
25. With the grille shutter on a flat and stable surface:
a. Remove the flap by drilling or breaking the two
plastic rivets.
b. Remove the shutter motor from the assembly by
removing the two screws with a T-20 Torx driver.
NOTE: Do not let shaft rotate after removal.
Figure 12
Figure 14
Temperature
sensor
Clips
Shutter Bolts
a.
b.
Figure 13
