Problem solving guide
117
Process-related faults and messages
Problem
Cause and remedy
Drying during programme de-
activated
Drying cannot be selected at the start of a programme be-
cause drying is not available for the selected programme.
Start the programme without drying.
Or:
Have the drying parameters for this programme adjusted
by the W&H Customer Service Department.
Wrong code entered
The PIN code entered is not the same as the code saved.
Enter the PIN code again.
Report the loss of the PIN code to the W&H Customer
Service Department.
Test programme: test object
can now be removed
This is not a fault.
A test programme is running to check performance. At cer-
tain points in the programme the sequence is interrupted so
that samples can be taken.
Take a sample.
or
Wait. The programme will continue automatically in ap-
prox. 30 seconds.
or
Continue the programme without delay by pressing the
Start/Stop
button.
Programme cancelled
This is not a fault.
A programme which was running was cancelled by the
user.
The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.
Programme continued
This is not a fault.
The process of cancelling a programme was not com-
pleted.
The programme which was running continued without inter-
ruption.
Peak load cut-out
This is not a fault.
Individual components of the machine are paused while
there is a peak load signal from your energy management
system.
All settings reset
This is not a fault.
A user has restored factory default settings.
Confirm the message with
OK
.