WALTERSCHEID SW40, Operating Manual

Page: 122 / 156

SAFETY INSTRUCTIONS
18
3.3 Product Safety
3.3.1 Safe Operation of the Machine
Only one person is permitted to operate the machine if there are no
persons in the danger zone of the special tool. Observe the chapter
"Danger zone and danger points", page 11.
3.3.2 Safety devices and protection equipment
•
Only operate the special tool if all safety devices and protective
equipment have been installed properly and are completely func-
tional.
Defective or removed safety devices and protective equipment
can result in dangerous situations.
•
Check all safety devices and protection equipment for externally
recognisable damage and functionality before you put the spe-
cial tool into operation.
3.3.3 Structural Changes
•
Structural changes, attachments or conversions to the special
tool must only be made with the manufacturer's written permis-
sion.
•
In the case of non-approved structural changes, attachments or
conversions, the declaration of conformity and the CE marking of
the special tool lose their validity.
•
Only use original parts or conversion and accessory parts ap-
proved by the manufacturer so that:
o
the declaration of conformity and the CE marking of the
special tool retain their validity,
o
the faultless function of the special tool is guaranteed.
•
The manufacturer is not liable for damage caused by:
o
unauthorised modifications of the special tool,
o
non-approved conversion and accessory parts,
o
welding and drilling work on load-bearing parts of the
special tool.
3.3.4 Spare and wear parts and auxiliary materials
Replace defective parts immediately.
Only use original parts from the manufacturer or parts approved by
the manufacturer for this. If spare and wear parts from third party
manufacturers are used, it is not guaranteed that they have been
designed and produced in accordance with load and safety.
The manufacturer accepts no liability for damage caused by the use
of non-approved spare and wear parts or auxiliary materials.