Operating Instructions
FX66, FX85/R, FX110/R, FX140/R
PTO Skidding Winch
30
5.10.7 Synchronize Transmitter and
Receiver
In the event it is necessary to synchronize a new
transmitter and receiver, use the following steps:
1.
Turn the transmitter OFF and disconnect power
from the receiver.
2.
To get the hand-held transmitter to
Teach
mode,
press and hold the POWER button for 10 seconds
until both LEDs are flashing.
3.
Power up the receiver. (On older models, remove
the cover and place a jumper wire across the
TEACH ID jumper inside the receiver. See
illustration.)
00611
1
2
3
Fig. 28 –
Receiver with Cover Removed
1. TEACH ID Jumper (Older Models)
2.
Error Code LED – Red
3. Signal indicator – Green
4.
The green LED stops flashing stays on
continuously when the new signal is learned.
Remove the wire and store it on one pin.
5.
Teach mode is now complete.
6. Operating Instructions
6.1 Pre-start Checklist
Before operating the winch, perform the following
pre-start checks.
A Pre-start Checklist is provided for both personal
safety and to keep the winch in good mechanical
condition.
Pre-start Checklist
Check that the integral plastic journal shield
on the PTO shaft can spin freely.
Check and lubricate the PTO shaft following
the schedule outlined in the Maintenance
section.
Check the condition of the cable. Replace if
kinked, frayed or if it has any broken strands.
Check the condition of the winch clutch.
Check that all bearings turn freely. Replace
any that are rough or seized.
Check and make sure that all covers and
guards are in place, secured and functioning
as designed.
Check all fasteners and tighten as required.
Make sure equipment is working and in good
repair.
Check that personal protection equipment
including hard hat, safety glasses, safety
shoes, safety vest, hearing protection and
gloves are being used and in good repair.
Check that loose fitting clothing or jewelry is
not worn. Loose, long hair is tied back.
Summary of Contents for FX110R
Page 49: ......
Page 50: ...www wallensteinequipment com ...
