34
BXTR6438
4.5 Machine Break-In
Although there are no operational restrictions on the
Wood Chipper when used for the first time, it is rec-
ommended that the following mechanical items be
checked:
A.
After operating for 1 hour:
1. Inspect the axle, tires, wheels, and hub mainte
-
nance.
2. Check alignment of pulleys. Align as required.
3. Check belt tension. Adjust as required.
4. Torque all fasteners and hardware.
5. Check condition of rotor bearings.
6.
Check the condition and clearance of the twig-
breaker, rotor and ledger blades. Adjust as
required.
7. Check for entangled material. Remove all en
-
tangled material before resuming work.
8.
Check tire pressure. Inflate as required.
9. Check condition of electrical and hydraulic com
-
ponents. Keep all components in good condition.
10.
Check all fluid levels. Top up as required.
B.
After operating for 8 hours:
1. Repeat steps 1 through 10.
2. Go to the normal servicing and maintenance
schedule as defined in the Maintenance Section
C.
After operating for 20 hours:
Check fluid level in the fluid coupling as described
under fluid coupling maintenance in the Transfluid
installation and maintenance manual.
4.6 Engine Controls
Refer to the Kohler® engine manual for further
explanation on engine controls.
01030
1
2
3
Fig. 9 –
Engine Controls
1. Throttle Lever
2. Choke Lever
3. Ignition Switch
Throttle
This lever controls engine
speed. Slide the lever
to the left to increase
engine speed and right to
decrease.
