27
BXTR6438
Max Feed Speed
MAX FEED
SPEED
0%
Sets the maximum feed roller speed in 5% increments.
The value is shown as a percentage of the maximum
speed (100%).
•
Set
Max Feed Speed
higher for larger chip size. It can be
set and left at 100%.
•
Set it lower close to
Min Feed Speed
for smaller consistent
chip size.
Min Feed Speed
MIN FEED
SPEED
0%
Sets the minimum feed roller speed in 5% increments.
The value is shown as a percentage of the maximum
speed (100%). Setting
Min Feed Speed
higher allows
larger chip size and prevents the chipper from slowing
up as much when wood is put through.
(
Min Feed Setting
cannot be set any higher than 5%
below
Max Feed Setting
.)
Feed Start Speed
FEED START
SPEED
0000
Sets the rpm point where feed rollers start up.
Min Rotor rpm
MIN ROTOR
RPM
0000
Sets the low rpm point where the feed rollers auto-
reverse. If the rotor speed slows down under load
below this setting, P3 auto-reverses the feed rollers.
Once the rotor regains speed, Forward feed resumes.
If the engine stalls out, the
Minimum Rotor rpm
is set
too low.
01251
FEED SETTINGS
MAX FEED
SPEED
MIN FEED
SPEED
FEED START
SPEED
MIN ROTOR
RPM
0%
0%
0000
0000
Programming Hints
The factory settings provide good overall performance
for the machine selected, however you may choose to
customize performance. Here are some helpful hints:
•
For very heavy brush – decrease
Max Feed Speed
to slow
feed roller speed.
•
To get smaller, consistent chip size – decrease
Max Feed
Speed
closer to
Min Feed Speed
.
•
Larger chip sizes and more aggressive feeding – Leave
Max Feed Speed
at 100% and raise
Min Feed Speed
.
