31
BXT Series
6.10 Storage
6.10.1 Placing In Storage
After the season's use or when the machine will not be used for
a period of time, completely inspect all major systems of the
Trailer Wood Chipper. Replace or repair any worn or damaged
components to prevent any unnecessary down time at the
beginning of the next season.
Refer to the engine manual for information on storage.
Follow this procedure before storing:
1.
Remove all material from the machine.
2.
Thoroughly wash the machine to remove all dirt, mud or
debris.
3.
Inspect all rotating parts for entangled material. Remove all
entangled material.
4.
Check the condition of the belts and pulleys. Replace or
adjust as required.
5.
Add fuel stabilizer to the fuel tank.
6.
Run the machine a few minutes to dry the moisture from
inside the machine.
7.
Turn fuel valve off.
8.
Move the feed hopper up and lock.
9.
Touch up all paint nicks and scratches to prevent rusting.
10.
Remove ignition key and store in a secure place.
11.
Remove the battery and store it in a cool, dry area on
wooden blocks or a wooden pallet. Charge it monthly to
maintain an adequate charge.
12.
It is best to store the machine inside. If that is not possible,
cover with a waterproof tarp and tie down securely.
13.
Store in an area away from human activity.
14.
Do not allow children to play around the stored unit.
When removing this machine from storage, follow this
procedure:
1.
Remove the tarpaulin if covered.
2.
Install and connect the battery.
3.
Bring the ignition key.
4.
Review and follow the pre-operation checklist.
Fig. 21 –
STORED
IMPORTANT! If the machine has been stored for more than
6 months, warm the engine by running it for 2-3 minutes and
drain the oil. Change the oil while the oil is warm to remove
any condensation. Refer to Maintenance section.
