24
BXT Series
6.2 Before Startup
1.
Check the engine oil level. See
2.
Open the fuel valve.
3.
Check fuel level
4.
Check the engine air cleaner. See
5.
Review Operating Safety.
6.
Clear the area of bystanders.
7.
Make sure each operator is trained and familiar with the set
up and operation of the wood chipper.
8.
Perform the Pre-operation Checks.
9.
Survey the work site and place the chipper in a clear, level
work area. Park machine so that engine exhaust is not
blowing towards the operator.
10.
Leave the chipper attached to the tow vehicle if extra
stability is required. Set park brake on tow vehicle.
11.
Lower the front jack stand. Insert snap lock pin.
12.
Direct discharge chute away from the operator.
6.2.1 Pre-Operation Checks
Check the following each time the wood chipper is used:
Area to Check
Check the tension and alignment of the belt.
Adjust as required.
Check the rotor housing and discharge chute. Remove any
blockages, twine, wire or other material that has become
entangled.
Check engine oil level.
Check fuel level.
Check the condition and clearance of the twig breaker, rotor and
stationary blades. Adjust or replace as required.
Check condition of the battery and other electrical components.
Keep all components in good condition.
Check and ensure that all covers, guards and shields are in place,
secured, and can function as designed. Check the condition of the
feed hopper safety curtain.
Check that rotor bearings turn freely. Replace any that do not turn
smoothly or are seized.
Check and inspect tires, wheels, and hubs.
Check and tighten all fasteners. Make sure the equipment is in
good condition.
Check that appropriate equipment for personal protection is
available and being used. Check that jewelry, loose-fitting clothing
are not worn. Make sure long hair is tied back.
6.3 Machine Break-In
Although there are no operational restrictions on the Wood
Chipper when used for the first time, it is recommended that the
following mechanical items be checked:
After operating for 1 hour:
1.
Check alignment of pulleys. Align as required.
2.
Check belt tension. Adjust as required.
3.
Torque all fasteners and hardware.
4.
Check condition of rotor bearings.
5.
Check the condition and clearance of the twig-breaker, rotor
and stationary blades. Adjust or replace as required.
6.
Check for entangled material. Remove all entangled material
before resuming work.
7.
Check tire pressure. Inflate as required.
After operating for 10 hours:
8.
Repeat steps 1 through 7 listed above.
9.
Change engine oil. (See engine owners manual.)
10.
Go to the normal servicing and maintenance schedule as
defined in the Maintenance Section.
