Wallace & Tiernan SERIES V-2000, Manual

Page: 4 / 132

WT.025.055.004.UA.IM.0814
MANUAL CHLORINATOR - 3000LB/24HR
EVOQUA W3T109620
INTRODUCTION
This instruction book provides installation, operation, and maintenance instruc-
tions for the Evoqua Water Technologies Series V-2000 (Chlorine) Gas Feeder
(control module and injector). Of necessity, more information is provided than
applies to each specific installation; disregard those details that do not apply
to your installation.
Instructions for accessory equipment, where applicable, are provided in sepa-
rate books included with that equipment.
The complete gas feeder consists of a control module, an injector, and a vacuum
regulator. The vacuum regulator is covered by a separate instruction book
provided with that equipment.
WARNING: DO NOT USE THIS EQUIPMENT FOR SWIMMING POOL, WA-
TER PARK, OR SIMILAR RECREATIONAL APPLICATIONS. IT IS NOT SOLD
FOR SUCH USE.
The Evoqua Water Technologies Gas Feeder is designed to meter and control
the flow of chlorine gas. An injector accepts this flow of gas, mixes it with wa-
ter, and delivers the resultant solution to the point of application. By using a
selection of rotameters and valve seats, the gas feeder may be adapted to meet
a wide range of capacity requirements. Thus, as requirements change over a
period of time, the capacity of the gas feeder may be changed accordingly. A
large indicator scale on the rotameter permits a direct reading of the rate of
gas feed in pounds per 24 hours. A simple adjustment permits setting the feed
rate at any value within the range of the gas feeder. Once set, the feed rate will
remain constant unless manually changed by the operator. The gas feeder is
normally equipped with a two-inch variable throat injector.
WARNING: HAZARDOUS GAS IS PRESENT IN THIS EQUIPMENT DURING
NORMAL OPERATION. TO AVOID POSSIBLE SEVERE PERSONAL INJURY OR
DAMAGE TO THE EQUIPMENT, READ THIS INSTRUCTION BOOK AND THE
APPROPRIATE GAS MANUAL BEFORE CONNECTING THIS EQUIPMENT TO
A SUPPLY OF GAS. OPERATION AND MAINTENANCE OF THIS EQUIPMENT
MUST BE RESTRICTED TO TRAINED, QUALIFIED PERSONNEL WHO ARE
COMPLETELY FAMILIAR WITH THESE INSTRUCTIONS. CONSULT FACTORY
FOR APPLICATIONS AGAINST A NEGATIVE HEAD (PARTIAL VACUUM) OR
A POSITIVE BACKPRESSURE OF LESS THAN 1.0 PSI (28 INCHES OF WATER)
IN THE SOLUTION DISCHARGE LINE.
NOTE: When ordering material always specify model and serial number of
apparatus.
!
!
Introd.