Walkera ZHUN, Quick Start Manual

Page: 9 / 26

9
ZHUN
Quick Start Guide
Walkera All Rights Reserved
1
4.3 Installation of fire extinguishing tank and dry powder conveying pipe
Hang the fire extinguishing tank in
place on the holder and tighten the
hand tightening screw.
Install the dry powder conveying
pipe to the dry powder conveying
pipe holder on the aircraft' s tripod
and fix it with hand-tightening the
screw.
Connect the fire extinguishing tank
power cord.
3 2
Fig.5.0-1 Fig.5.0-2
5.0 Check Battery Levels
Turn on the remote controller and Aircraft Battery to check the battery level.
Be sure the battery was fully charged at the first use.
1) Press the power button last for 2~3 seconds to turn on the remote controller.
2) Press the Aircraft battery level detection switch to turn on the battery indicator (green light is on).
Low High
Low
High
First unscrew the protective plugs
at the fire extinguisher tank and the
dry powder conveying pipe joints,
and then screw the protective plugs
together for store.
Check if the gasket in the dry
powder conveying pipe joint
nut is detached. If it has fallen
off, put it back in the nut.
Screw the dry powder conveying
pipe joint nut into the fire extinguisher
tank joint in the direction of the red
arrow until it is tighten.
4 5 6
WKRC-H15
Z
Common
GPS
Manual
Take off
Landing
C
Power
RTH
D