Walkera ZHUN, Quick Start Manual

Page: 10 / 26

LiHV
20.0A
FAST CHARGE
Off-line
ZHUN
Quick Start Guide
10
Walkera All Rights Reserved
Fig.6.2-1
Fig.6.2-2
Fig.6.2-3
Fig.6.2-4
1) Power on: Connect the AC power, turn on the power switch, the charger will “click”, the fan will rotate once, and
the LCD will display the following interface.
1) Connect the charger to the AC power (100 ~ 240v 50/60Hz).
2) Please turn off the remote controller before charging.
3) The charging completion indicator of remote controller turns green means remote controller charging finished
completely.
Tip: The device is equipped with a build-in lithium battery
of 7.4V9000mAh,please use DC 15V4A for charging.
6.0 Charge the Batteries
6.1 Remote control charging
Steps
6.2 Aircraft battery charging
Connect the balance charging cable as shown in red arrow.
Connect the battery charging cable as shown by the blue arrow (Choose any red and black cable).
2) Connect the battery: Please connect the battery and charger according to the Schematic diagram below.
(Note: The number of lithium battery packs that support charging is 12 knots; the battery charging cable and
the balance port must be connected to the charger at the same time.)
Battery Type(LiPo/LiHV)
Charging current (1.0-20.0 A)
Working modes (fast charge,balance charge & storage)
Synchronous status(Off-line, Master, Slave)
/ /
START STATUS STOP
3) Start charging: Press both and at the same time and last for 5 seconds until the battery type is LiHv on
the screen, Press the button for 2 seconds and then press the button to confirm charging.
Charging port
Fig.6.1
LiPo LiHV
20 .0 A
FAST CHARGE FAST CHARGE
Off-line Off-line
20 .0 A
20.0A
LiPo
FAST CHARGE
Off-line