Tip: Before the operation, it is recommended to adjust the elevation angle of the launch tube to 4.5°.
Set the automatic obstacle avoidance safety distance in the WKDrone-ZHUN interface to 5 meters,
in order to hit the target more accurately, and turn on the auxiliary aiming laser switch to automatically
avoid the obstacle switch. Slide to the on position and the flight mode must be switched to GPS mode.
21
Walkera All Rights Reserved
ZHUN
Quick Start Guide
5.00m
4
3
5
m
15
14
5.00m
4
3
5
m
15
14
14.0 Fire fighting operation
14.1 Fire-extinguishing bomb work
When the aircraft flies to the target window
or 5 meters in front of the doorway, the
aircraft will automatically stop moving
forward, at which point you can manipulate
the direction rocker to aim at the target.
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the WKDrone-ZHUN
interface.
After aiming at the target, slide the
automatic obstacle avoidance switch to
the closed position in the WKDrone-ZHUN
interface.
Double-click the “ ” button and the
status indicator of fire extinguisher status
will red light.the fire extinguisher will fly
to the target,after 5 seconds of reaching
the target room, the dry powder will be
automatically sprayed to extinguish the fire.
1
2
1). Manual Landing, AUTO Landing or Return to Home function landing or low voltage landing.
2). After landing, the laser auxiliary sight should be turned off and the nozzle should be put away. Then remove the head cover and
disconnect the power of the aircraft (pull out the power plug), release the battery binding strap and remove the flight battery from
the aircraft.
3). Finally, turn off the power of the remote controller.
15.0 End flight
When the aircraft flies to the target window
or 5 meters in front of the door, the aircraft
will automatically stop moving forward, at
which point you can manipulate the direction
rocker to illuminate the auxiliary aiming
laser at the target point.
5.00m
4
3
5 m
15
14
5.00m
4
3
5
m
15
14
14.2 Spraying dry powder fire extinguishing
1
2
Double-click the “ ” button to turn on
the spraying dry powder. the status
indicator of fire extinguisher status will
green light after the fire has been successfully
extinguished, double-click the “ ” button
again to turn off the spraying.
1. It is strictly forbidden to direct the laser to any human body, animal, vehicle, etc., and the
operator is legally responsible for the injury caused by this.
2. When using a laser-assisted sight indoors or at close range, wear a laser-shield of the appropriate
wavelength to avoid refraction, reflection, and direct light to the eye;
3. In public places where there are many people, in order to avoid accidental injury to others,
the use of lasers should be stopped.
Upgrade port
Charge Port
15V 4A
Spray
Gimbal
UP
Green light
3
Upgrade port
Charge Port
15V 4A
Spray
Gimbal
UP
Gimbal
L
Extinguisher
3
Extinguisher
Spray
Spray
Red light
Summary of Contents for ZHUN
Page 1: ...www walkera com Sep 5th 2019 QUICK START GUIDE V1 0...
Page 25: ......