Sound Parameters
104
Iridium Manual
LFO Section
In addition to the main oscillators, Iridium is equipped
with six low frequency oscillators (LFOs) that can be used
for modulation purposes. Each LFO generates a periodic
waveform with adjustable frequency and shape.
The LFO Section for LFO 1
r
The basic parameters of all 6 LFOs can be edited via
the Panel parameter controls. More parameters are
accessible via the LFO display page.
LFO Panel Parameters
Select
Selects a LFO for parameter editing. The corresponding
LED shows the selected LFO 1 to 6.
Speed
Determines the frequency of the selected LFO. At low valu-
es it might take four minutes for the LFO to perform a
complete cycle while higher values are in the audible ran-
ge.
When the LFO
Sync
parameter is set to
On
, you can adjust
Speed Ratio
in musical values. The lowest possible value
is
1024
bars, meaning that a complete LFO cycle would
need 1024 bars.
Amount
Determines the amount of the selected LFO modulation
applied to all destinations. Since the modulation is in fact, a
multiplication of the source signal and this parameter, the
resulting amplitude depends on the type of modulation
source you select.
LFO Display Page
To access the LFO display page, press the LFO button. Tap
on the corresponding tab (
LFO1
to
6
) to select the desired
LFO you want to edit.
r
You can also switch through the LFOs by pressing
the LFO button again and again.
Summary of Contents for IRIDIUM
Page 1: ...User Manual...
