11
Operation
Operation Guide
1.
WALDORF ' FAST-FRI HPO' fryers have been designed to provide simplicity of operation and 100%
safety protection.
2.
Improper operation is therefore almost impossible, however bad operation practices can reduce the
oil/shortening life and produce a poor quality product. To use this appliance correctly please read
the following sections carefully;
•
Filling the Tank.
•
Lighting the Main Burners.
•
Setting the Operating Temperature.
•
Frying Temperature Guide and Care of Oil.
•
Draining and Cleaning.
Description of Controls
•
A commercial heavy duty, gas fired Fryer using Hi Power Output infra red burner system.
•
Available in the following model type:-
Gas Single 31 Ltr Pan fitted with manual, electronic thermostat.
•
All models are fitted with dual main burners and pilot burners with full electronic ignition system.
•
This model is single tank, fitted with a independent left and right hand burner systems.
•
The fryer features an Over Temperature Safety Cut Out system with Full Flame Failure Safety
Controls.
•
Snap action thermostat sensitive to changes in oil temperature.
•
Open tank design to simplify cleaning operation.
FN8130GHPO (Access Door Shown Removed)
Gas Control Knob
Temperature Graduations
90°C to 195°C.
Power ‘ON’ Indicator. (When
main power switch is ‘ON’).
Heating ‘ON’ Indicator. (When
thermostat is turned to a
selected Temperature.
Left and Right Lock Out Reset
Indicators.
Operating respective Switches
Resets the Burner Selected.
(Press and release to operate).
Turns power ‘ON’ and ‘OFF’ to
the unit. (Red LED Indicator
illuminates when switched
‘ON’).
Neon Indicator
(Green)
Neon Indicator
(Orange)
Neon Indicators
(Red)
Left and Right
Burner Reset
Switches
Main Power
Switch
Located Behind Main Access Door
Fig 4
C
AUTION
:
•
This appliance is for professional use and is only to be used by qualified
persons.
•
Only qualified service persons are to carry out installation, servicing or gas
conversion operations.
•
Components having adjustments protected (e.g. paint sealed) by the
manufacturer should not be adjusted by the user / operator.