356.805.003
12
Date: 2019-04-04
Mounting the load
The load on the unit can easily be mounted on the bracket using one or more of the ø12mm holes
[
A
] as shown below. Remove the four M8 bolts [
B
] to fully access the mounting bracket.
When using a secondary suspension [
C
] secured behind the mounting bracket, make sure to
minimize the slack in order to avoid collision with the motor gear and the tooth rack behind the
bracket.
Using heavy loads may force the unit to shut-down if the deacceleration is too fast, so if this is
the situation then decrease the speed and ramp to a lower level. For resetting the unit, power
off the unit for op to 60s and repower.
WARNING! Maximum
bolt length behind the
bracket is 40mm
WARNING! Minimize
slack when using a
secondary suspension
A
B
C
