WAGO I/O SYSTEM FIELD 765-2704/200-000, Product Manual

Page: 4 / 42

765-2704/200-000 Provisions
4 Product manual | Version: 1.0.0
2AO FLD IOL CONV 0-10V
1 Provisions
This document applies to the following product:
ü
765-2704/200-000 (2AO FLD IOL CONV 0-10V) 2-Channel Analog Output; IO-Link
Converter; 0 ... 10 V; 2 x M12 Connector
Product detail page
ü
www.wago.com/765-2704/200-000
The product must only be installed and operated in accordance with the operating instruc-
tions. Knowledge of the operating instructions is required for proper use. You can find all
documents and information on the detailed product page.
Additional document
•
&
WAGO IO-Link Configurator
1.1 Intended Use
The product 765-2704/200-000 controls a connected actuator or another device that has
an analog input within the output range from 0 to 10 mA.
• The product is intended for indoor use.
• Operation of the product in other application areas is only permitted when correspond-
ing approvals and labeling are present.
Improper Use
Improper use of the product is not permitted. The following cases in particular constitute
improper use:
• Non-observance of the intended use
• Use without protective measures in an environment in which salt water, salt spray mist,
icing, corrosive fumes, explosive gases, direct sunlight and ionizing radiation can occur
• Use of the product in areas with special risk that require continuous fault-free operation
and in which failure of or operation of the product can result in an imminent risk to life,
limb or health or cause serious damage to property or the environment (such as the
operation of nuclear power plants, weapons systems, aircraft and motor vehicles)
Warranty and Liability
The terms set forth in the General Business and Contract Conditions for Delivery and
Service of WAGO GmbH & Co. KG and the terms for software products and products with
integrated software stated in the WAGO Software License Contract – both available at
ü
www.wago.com – shall apply. In particular, the warranty is void if:
• The product is improperly used.
• The deficiency (hardware and software configurations) is due to special instructions.
• Modifications to the hardware or software have been made by the user or third parties
that are not described in this documentation and that has contributed to the fault.
Individual agreements always have priority.