82
• Feldbus Coupler/Controller
Fieldbus Controller 750-806
WAGO-I/O-SYSTEM 750
DeviceNet
3.2.6.2 IEC 61131-3 Program Transfer
Program transfer from the PC to the Controller following programming of the
desired IEC 61131 application can be made in two different ways:
•
via the serial interface or
•
via the fieldbus.
One suitable communication driver each is required for both types.
More information
For information on the installation of the communication drivers as well as
details regarding the use of the software, please refer to the
WAGO-I/O-
PRO
32
manual (order No.: 759-122 / 000-002).
3.2.6.2.1 Transmission via the Serial Interface
Use the WAGO communication cable to produce a physical connection via the
serial interface. This is contained in the scope of delivery of the programming
tool IEC 61131-3, order No.: 759-332/000-002, or can be purchased as an ac-
cessory under order No.: 750-920.
Connect the COMX port of your PC with the communication interface of your
Controller via the WAGO communication cable.
A communication driver is required for serial data transmission. In
WAGO-
I/O-
PRO
32,
this driver and its parameters are entered in the
"Communica-
tion parameters"
dialog.
1.
Start the
WAGO-I/O-
PRO
32
software via ’Start/Programs’ or by double
clicking on the WAGO-I/O-PRO-32 symbol on your desk top.
2.
In the
"Online"
menu click on the
"Communication parameters"
menu
point.
The dialog "Communication parameters" opens. The basic setting of this
dialog has not yet any entries.
3.
In the selection window mark the desired driver on the right-hand dialog
side (i.e.
"Serial RS232"
), to configure the serial connection between PC
and the Controller).
4.
In the center window of the dialog, the following entries have to appear:
- Parity:
Even
- Stop bits:
1
If necessary, change the entries accordingly.
You can now commence testing the Controller.
