Mounting 33
787-2861 Electronic Circuit Breaker
Manual
Version 1.3.1
Pos: 55 /All e Seri en (Allgemei ne Module)/Ü berschriften/Ebene 1/M onti eren - Ü berschrift 1 @ 3\mod_1225446744750_21.docx @ 24900 @ 1 @ 1
5
Mounting
Pos: 56.1 /All e Seri en ( Allgemei ne Module)/Sicherheits- und sonstige Hi nweise/Achtung/Achtung: Elektrostatische Entladung ver mei den! - DIN EN 61340-5- 1/-3 @ 6\mod_1260181364729_21.docx @ 46759 @ @ 1
Avoid electrostatic discharge!
The devices are equipped with electronic components that may be destroyed by
electrostatic discharge when touched. Please observe the safety precautions
against electrostatic discharge per DIN EN 61340-5-1/-3. When handling the
devices, please ensure that environmental factors (personnel, work space and
packaging) are properly grounded.
Pos: 56.2 /Serie 787 (EPSITRON)/M ontier en/Montage-D emontage 787- 2861 @ 23\mod_1436253250604_21.docx @ 185382 @ 233 @ 1
5.1
DIN-35 Rail
The device is designed for mounting on a DIN-35 rail.
5.1.1
Mounting on DIN-Rail
Install the device as per EN 60715 by snapping it onto the DIN-rail. (see figure
“Mounting”):
Figure 5: Mounting
1.
Place the device with its DIN-rail guide on the top edge of the DIN rail.
2.
Press the device onto the DIN-rail [1] while simultaneously pulling on the
snap-in mounting foot (c) [2] until it locks into place.
3.
To ensure secure fastening on the DIN-rail, fit end clips (e.g., Item No.
249-116
) on either side of the device (with a block arrangement: on either
side of the devices).
Use separators (Item No.
209-191
) between adjacent contacts for safe
disconnection when devices have been snapped in on each side.
