WAGO 787-1216, Manual

Page: 23 / 42

0787-1216 Properties
Product manual | Version: 1.0.0 23
Compact Power Supply
3.9 Standards
The product meets the following standards:
Table 22: Standards: Mechanical and Climatic Environmental Conditions
Standard Test Value
Mechanical Environmental Conditions
EN 60068-2-6 f = 5 …150 Hz: 1g, 3.5 m
IEC 60068-2-27 shock 15g, 11 ms, 6 shocks per axis and direction, half-sine
EN 61131-2, sec. 4.3 Freefall ≤ 300 mm (packaged in the product packaging)
Climatic Environmental Conditions
EN 60870-2-2 3K3 (except for low air pressure)
Table 23: Standards: EMC – Immunity to Interference
Standard Title
EN 61204-3 Low-Voltage Switch Mode Power Supplies – Part 3: Electromagnetic Com-
patibility (EMC)
EN 61000-4-2 Part 4-2: Testing and measurement techniques – Electrostatic discharge im-
munity test
EN 61000-4-3 Part 4-3: Testing and measurement techniques – Radiated, radio-frequency,
electromagnetic field immunity test
EN 61000-4-4 Part 4-4: Testing and measurement techniques – Electrical fast transient/
burst immunity test
EN 61000-4-5 Part 4-5: Testing and measurement techniques – Surge immunity test
EN 61000-4-6 Part 4-6: Testing and measurement techniques – Immunity to conducted dis-
turbances, induced by radio-frequency fields
EN 61000-4-8 Part 4-8: Testing and measurement techniques – Power frequency magnetic
field immunity test
EN 61000-4-11 Part 4-11: Testing and measurement techniques – Voltage dips, short inter-
ruptions and voltage variations immunity tests
Table 24: Standards: EMC – Emission of Interference
Standard Title
EN 61204-3 Low-Voltage Switch Mode Power Supplies – Part 3: Electromagnetic Com-
patibility (EMC)
3.10 Special Requirements
Observe the following:
• Perform installation according to the local conditions, applicable regulations (e.g., VDE
0100), national accident prevention specifications (e.g., UVV-VBG4 or DGUV Regula-
tion 2) and accepted technical regulations.
• This product is intended for installation in electrical systems or machines and fulfills the
requirements of the Low Voltage Directive.
When installing in machines, the following also applies:
• When installing in machines, normal operation must not commence until it is deter-
mined that the machine complies with the requirements of the Machinery Directive, EN
60204.
• Commencement of normal operation is allowed only on the condition of compliance
with the EMC Directive.
• The manufacturer of the system or machine is responsible for ensuring compliance
with the limit values required by EMC legislation.