WAGNER HT4500, Operating Instructions Manual

Page: 8 / 96

7. ASSEMBLY AND ADJUSTMENT
Prior to assembly and adjustment always unplug the tool and allow to cool
fully.
The air temperature can be adjusted to suit a wide range of applications. The table below
suggests settings for different applications.
Setting Applications
1
0-50ºc

Drying paint, varnish colour shade samples, filler, adhesives, construction
joints and stucco forms

Drying wet timber prior to filling

Removing stickers

Joining adhesives-large-surface gluing with contact adhesives, activation of
pressure-sensitive adhesives, acceleration of bonding processes, releasing
of bonding points as well as releasing or bonding of edge band or veneer

Waxing and de-waxing

Shrinking PVC wrapping and insulation tubes

Thawing icy stairs and steps, door locks, car boot lids, car doors or
>>>> water pipes
2
50-650ºc

Welding of thermoplastic polymer, flooring materials of PVC and linoleum,
PVC-coated fabric, tarpaulins and foils

Bending plastic pipes and sheets

Soldering joints, tin, special silver solder, SMD elements, cable lugs

Loosening rusted or tightly-fastened nuts and bolts

Removing old and even thick coatings of oil paint , lacquer, varnish and
synthetic plaster
If you are not sure about the correct setting, start with a low temperature
setting and gradually increase the temperature until you achieve optimum
results.
ATTENTION: RISK OF FIRE! Do not excessively heat the wood surface.
8
EN