7
starting operation
fc9900 Plus
4
Starting operation
i
Before connecting to the mains supply make
sure that the mains voltage corresponds to the
operating voltage on the rating plate. The unit
must be connected with a properly earthed
shockproof socket.
1.
Screw air hose end (anti-kink spring) onto the turboblower.
Couple air hose to the paint spray gun.
2.
Open closing lever on the paint container, remove paint
container.
3.
Fill paint container with coating material.
4.
Check that the paint container seal is clean and is seated
correctly.
5.
Clip the container onto the spray gun and secure with the
closing lever.
6.
Switch the turbo-blower on.
7.
Point the paint spray gun at the object to be sprayed.
8.
Determine the settings for the spray pattern, spray jet
width, amount of material, amount of air and ascending
feed pipe settings, see fig. 4 - 10 and the description page
7/8.
9.
Operate trigger on the paint spray gun.
4.1
Setting the fc9900 pluS Spray gun
Spray pattern Selection (fig. 4)
a = vertical flat jet
for horizontal surfaces
b = horizontal flat jet
for vertical surfaces
c = round jet
for corners and edges and places difficult to
access.
A
B
C
Setting the required Spray pattern (fig. 5)
Turn the air cap (1) to the required spray pattern position.
Attention
Never pull trigger while adjusting the air cap
settings.
1
