10
finisHing work and cleaning tHe unit
fc9900 Plus
6
finiShing work and cleaning the
unit
1.
Switch the unit off.
2.
Hold the paint spray gun in the original container. Press the
trigger to release the pressure in the spray gun container.
3.
Undo the paint container closing lever and remove the
container.
4.
Empty the remaining coating material into the original
container.
5.
Fill the spray gun container with solvent or water and fit
onto the spray gun.
Only use solvents with a flash point above 21 °C.
6.
Shake the paint spray gun well.
7.
Switch the unit on and spray the solvent or water into an
open container.
Never spray into a container with only a small
opening (bunghole)!
8.
Repeat this procedure until the solvent or water coming
out of the tip is clear.
Then empty the paint container completely.
Never leave solvents in the spray gun container;
this may cause pressure to build up in the
container.
Always keep the paint container seal clean of left over
coating material and check regularly for signs of damage.
9.
Switch the unit off.
10.
Clean the outer surfaces of the paint container and paint
spray gun with a cloth soaked in solvent or water.
i
Do not leave the FineCoat 9900 Plus spray gun
immersed in solvent for extended periods! (The
seals and air pipe on non-return valve may swell,
preventing them from functioning properly.)
11.
Unscrew adjusting ring, remove air cap and spring plate.
Unscrew nozzle. Clean air cap, tip and needle with brush
and solvent or water.
i
Never use sharp metal objects to clean the
nozzles or air channels of the FC9900 Plus spray
gun.
12.
Apply a fine coat of silicone-free oil to the marked areas
(fig 14).
13.
If the paint spray gun is not used for any length of time, it
should be cleaned and protected by applying a fine coat of
silicone-free oil.
