background image

 

2021 

 
Operating WAGENER SPARKY RU 

– Rural Woodburner

 

 

Dry, seasoned wood at less than 25% moisture content should be used at all times. 

Try to buy wood well in advance and store so that the air can circulate through the pile to assist drying. 
Wet, unseasoned wood can cause creosote problems, especially if it is burned slowly. Care should be taken 
to ensure that the fire is actually burning and not just smouldering which over a period of time can create 
creosote build-up and flue blockages. 

DO NOT

 burn driftwood, chipboards, painted, stained or treated timbers or glossy print material as they 

will all damage your Sparky RU and flue and void your warranty. Coal must not be used in this fire. 

NOTE

: The heat output level of Sparky RU is controlled not only by the air control but also by the type and 

quality of fuel in the firebox. 

For best results the fuel should be loaded front to back

Fire bricks

 can hold moisture and may crack in a hot fire. Have 2 or 3 small fires to “condition” bricks or  

alternatively bricks can be removed and dried in the sun or hot water cupboard.  
 

When Sparky RU is not in use close the air

 

control

 to prevent the fire drawing air back down the flue 

and into the firebox as moist or salt laden air can cause deterioration of the appliance over time.

 Cleaning out 

the firebox at the end of winter usage and spraying the inside steel box with CRC can prevent surface rusting.

 

 

First Burn on a New Appliance or Repainted Appliance 

On INITIAL LIGHTING, the high temperature paint used on Sparky RU will give off smoke and odour for a 
period of time. Open your doors and windows to ensure adequate ventilation! 

Please follow information

 

“High Temperature Paint” enclosed in your installation pack 

on safety and the paint curing process. 

 

Start Up 

1.

 

Open the air control to the fully open position by sliding the wire air control knob above the door 
hard to the right so that holes are fully open. 

2.

 

Open the firebox door. Place crumpled newspaper in the base of the firebox.  
Stack kindling around the newspaper like an Indian Tepee and light the newspaper (or firelighters if 
using) leaving the door slightly ajar until the kindling is well alight. Then add 2 or 3 small logs of wood 
and close the door. Do not adjust the air control.  

3.

 

To add larger logs or to refuel always ensure that the air control is on full supply and open the door 
slowly. Add logs ensuring air spaces between to allow oxygen for burning and again only readjust the 
air controls to the desired setting when the new fuel is well alight and the fire is burning well. 

4.

 

It should not be necessary to fill the firebox to capacity. Smaller loads of wood burned on half air 
supply will produce more heat per kg of wood. Note: flue length, outside wind conditions and the like 
may affect the performance of the fire. 

5.

 

Please Note: Over Firing will damage your stove & flue system and will void your warranty. 
Please refer to page 6 - Over firing, Causes and Remedies. 

 

Stove Top Cooking  

Establish a good fire and allow Sparky RU to heat up. Never cook food directly on the top of the stove. 
Always use pots, pans and appropriate cooking implements. A suitable raised trivet on the stove top will 
provide slower cooking options. Avoid spills which can be detrimental to the paint finish. If a spill occurs clean 
gently using a soft cloth. Avoid scratching or marking the surface. Wear and tear caused overtime can be 
touched up with High temperature paint. (See instructions) 

 

Extended Burn Times 

Ensure that your Air Control is fully open and that you have a good base of hot embers. Add a good load of 
larger pieces of wood. Allow to burn for 10-20 minutes before moving the Air Control to the left to slow. 
Sparky RU will burn away for longer periods on low. 

At the end of an extended burn 

move air control right to full air supply. Rake the embers and re-establish 

the fire by adding a few small split logs and allow the firebox temperature to build up before adding the 
balance of the fuel. The addition of large quantities of cold fuel to a low fire will reduce the firebox 
temperature dramatically and this may result in smouldering or ‘losing’ the fire. Proceed with fire as before. 

Summary of Contents for Sparky RU










Reviews: